Manufacturing of Porous Ultrahigh Density Polyethylene Using Subcritical Water

2015, №1

сс. 70-77

D.Yu. Zalepugin, A.V. Maksimkin, N.A. Tilkunova, I.V. Chernyshova, F.S. Senatov, M.I. Vlasov

Key words: ultrahigh density polyethylene, subcritical water, porosity, implant

The method of subcritical water extraction of NaCl from ultrahigh density polyethylene
(UHDPE) samples is developed as a stage in the manufacturing of porous polymer —
a promising material for implant production. Optimal process parameters were
determined as follows: pressure 250 atm, temperature 120 °С, water flow rate 3 g/min.
This method provides with a tenfold reduction of salt extraction time (from 10 to 1 h).
The main pore diameter of UHDPE determined by scanning electronic microscopy
ranges from 80 to 700 µm.

Translated article

doi:10.1134/S1990793115080126

Предыдущая статья Следующая статья

Цитировать

ГОСТ
7.0.100-2018

Залепугин, Д.Ю. Manufacturing of Porous Ultrahigh Density Polyethylene Using Subcritical Water / Д.Ю. Залепугин, А.В. Максимкин, Н.А. Тилькунова [и др.]. – Текст : непосредственный // Сверхкритические Флюиды: Теория и Практика.. – 2015. – Т. 10. – № 1. – С. 70-77.

TRANSLIT

Zalepugin, D.YU. Ispol'zovanie subkriticheskoj vody v tekhnologii polucheniya poristogo sverhvysokomolekulyarnogo polietilena / D.YU. Zalepugin, A.V. Maksimkin, N.A. Til'kunova [i dr.]. – Sverhkriticheskie Flyuidy: Teoriya i Praktika.. – 2015. – Т. 10. – № 1. – S. 70-77.

D.Yu. Zalepugin, A.V. Maksimkin, N.A. Tilkunova, I.V. Chernyshova, F.S. Senatov, M.I. Vlasov Manufacturing of Porous Ultrahigh Density Polyethylene Using Subcritical Water. Sverhkriticheskie Flyuidy: Teoriya i Praktika, 1, 70-77 (2015). https://doi.org/

Manufacturing of Porous Ultrahigh Density Polyethylene Using Subcritical Water

Цитировать

Спасибо. Ваши данные отправлены